user manual

Configure and Environment Commands
A-10 Installation Guide
A
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default
Slave Address Translation Address #2
Slave Address Translation Select #2
Slave Control #2
Master Enable #1 [Y/N]
Master Starting Address #1
Master Ending Address #1
00000000
00000000
0000
Y
02000000
EFFFFFFF
This register will allow
the VMEbus address
and the local address to
be different. The value
in this register is the
base address of the local
resource that is
associated with the
starting and ending
address selections from
the previous questions.
The default is 0.
This register defines
which bits of the
address are significant.
A logical one “1”
indicates significant
address bits, logical zero
“0” is non-significant.
The default is 0.
This defines the access
restriction for the
address space defined
with this slave address
decoder.
Setup and enable the
Master Address
Decoder #1.
This is the base address
of the VMEbus resource
that is accessible from
the local peripheral bus.
The default is the end of
calculated local
memory.
This is the ending
address of the VMEbus
resource that is
accessible from the local
peripheral bus.