Specifications

Administrator’s Handbook

246

set atm [vcc

] vpi { 0 ... 255 }

Select the virtual path identiﬁer (vpi) for VCC n.

Your Service Provider will indicate the required vpi number.

set atm [vcc

] vci { 0 ... 65535 }

Select the virtual channel identiﬁer (vci) for VCC n. Your Service Provider will indicate the required vci num-

ber.

set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |

ip-llc | ppoe-vcmux | pppoe-llc }

Select the encapsulation mode for VCC n. The options are:

Your Service Provider will indicate the required encapsulation mode.

set atm [vccn] pppoe-sessions { 1 ... 8 }

Select the number of PPPoE sessions to be conﬁgured for VCC 1, up to a total of eight. The total number of

pppoe-sessions and PPPoE VCCs conﬁgured must be less than or equal to eight.

Bridging Settings

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to forward non-TCP/

IP trafﬁc from one network to another. When bridging is enabled, the Motorola Netopia® Gateway maintains

a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are dropped. If the bridg-

ing table ﬁlls up, the oldest table entries are dropped to make room for new entries.

Virtual circuits that use IP framing cannot be bridged.

☛ NOTE:

For bridging in the 3341 (or any model with a USB port), you cannot set the bridge option off,

or bridge ethernet option off; these are on by default because of the USB port.

ppp-vcmux PPP over ATM, VC-muxed

ppp-llc PPP over ATM, LLC-SNAP

ether-llc RFC-1483, bridged Ethernet, LLC-SNAP

ip-llc RFC-1483, routed IP, LLC-SNAP

pppoe-vcmux PPP over Ethernet, VC-muxed

pppoe-llc PPP over Ethernet, LLC-SNAP