Specifications

190
then enter the configuration values appropriate for your site without having to enter com-
plete CLI commands.
When you are in step mode, the command line interface prompts you to enter required and
optional settings. If a setting has a default value or a current setting, the command line
interface displays the default value for the command in parentheses. If a command has a
limited number of acceptable values, those values are presented in brackets, with each
value separated by a vertical line. For example, the following CLI step command indicates
that the default value is
off and that valid entries are limited to on and off.
option (off) [on | off]:
on
You can accept the default value for a field by pressing the Return key. To use a different
value, enter it and press Return.
You can enter the CONFIG step mode by entering
set from the top node of the CONFIG hier-
archy. You can enter step mode for a particular service by entering
set service_name .
In stepping set mode (press Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>> set system
...
system
name (“Netopia-3000/9437188”): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
You can use the validate CONFIG command to make sure that your configuration set-
tings have been entered correctly. If you use the validate command, the Motorola
Netopia® Gateway verifies that all required settings for all services are present and that
settings are consistent.
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the validate command to verify your configuration settings at any time.
Your Motorola Netopia® Gateway automatically validates your configuration any time you
save a modified configuration.