User guide

232
set security ipsec tunnels name "123" local-id id_value
Specifies the NAT local ID value as specified in the local-id-type for the specified IPsec
tunnel.
☛ Note: If subnet is selected, the following two values are used instead:
set security ipsec tunnels name "123" local-id-addr ip-address
set security ipsec tunnels name "123" local-id-mask ip-mask
set security ipsec tunnels name "123" remote-id-type
{ IP-address | Subnet | Hostname | ASCII }
Specifies the NAT remote ID type for the specified IPsec tunnel.
set security ipsec tunnels name "123" remote-id id_value
Specifies the NAT remote ID value as specified in the remote-id-type for the specified
IPsec tunnel.
☛ Note: If subnet is selected, the following two values are used instead:
set security ipsec tunnels name "123" remote-id-addr ip-address
set security ipsec tunnels name "123" remote-id-mask ip-mask
Internet Key Exchange (IKE) Settings
The following four IPsec parameters configure the rekeying event.
set security ipsec tunnels name "123" IKE-mode
ipsec-soft-mbytes (1000) {1-1000000}
set security ipsec tunnels name "123" IKE-mode