User guide

191
CONFIG Commands
Netopia-3000/9437188 (top)>> set system
...
system
name (“Netopia-3000/9437188”): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
You can use the validate CONFIG command to make sure that your configuration set-
tings have been entered correctly. If you use the validate command, the Netopia Gate-
way verifies that all required settings for all services are present and that settings are
consistent.
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass
inspection!
You can use the validate command to verify your configuration settings at any time.
Your Netopia Gateway automatically validates your configuration any time you save a modi-
fied configuration.
CONFIG Commands
This section describes the keywords and arguments for the various CONFIG commands.
DSL Commands
ATM Settings. You can use the CLI to set up each ATM virtual circuit.
set atm option {on | off }
Enables the WAN interface of the Netopia Gateway to be configured using the Asynchro-
nous Transfer Mode (ATM) protocol.