User guide

122
This allows you to further modify the way the filter will match on the source address.
Enter 0.0.0.0 to force the filter to match on all source IP addresses, or enter
255.255.255.255 to match the source IP address exclusively.
5. Enter the Destination IP Address this filter will match on.
You can enter a subnet or a host address.
6. Enter the Destination Mask for the destination IP address.
This allows you to further modify the way the filter will match on the destination
address. Enter 0.0.0.0 to force the filter to match on all destination IP addresses.
7. If desired, you can enter a TOS and TOS Mask value.
See “Policy-based Routing using Filtersets” on page 133 for more information.
8. Select Protocol from the pull-down menu: ICMP, TCP, UDP, Any, or the
number of another IP transport protocol (see the table on
page 113).
If Protocol Type is set to TCP or UDP, the settings for port comparison will appear.
These settings only take effect if the Protocol Type is TCP or UDP.
9. From the Source Port Compare pull-down menu, choose a comparison
method for the filter to use on a packet’s source port number.
Then select Source Port and enter the actual source port number to match on (see
the table on page 111).
10. From the Destination Port Compare pull-down menu, choose a compari-
son method for the filter to use on a packet’s destination port number.
Then select Destination Port and enter the actual destination port number to match
on (see the table on page 111).
11. When you are finished configuring the filter, click the Submit button to
save the filter in the filter set.