User`s manual

Index
IN-2
I
N
D
E
X
Address Resolution Protocol (ARP) 1-30
address sizes 1-33
alternate boot device B-1
arguments 2-2
ADDR 2-4
EXP 2-2
PORT 2-6
ARP 1-30
AS command 3-4, 4-11
assembler 3-130, 4-1, 4-2, 4-11
assembler error messages 4-14
assembly language 1-2, 4-1
assert SYSFAIL* 1-22
assign
port 3-178, 3-181
serial port as console 3-220
assign value to variable 5-64
ATA (hard disks/CD-ROM drives) F-2
ATA/ATAPI controller-dependent er-
rors F-7
ATA/ATAPI firmware status codes F-6
ATAPI (CD-ROM drives) F-2
attach
printer to a port 3-168
symbol table to debugger 3-211,
5-111
attribute mask (IOSATM, IOSEATM)
5-22
attribute word 5-22
attribute word (IOSATW, IOSEATW)
5-23
Auto Boot 1-13
B
battery
power save mode 3-187
baud rate B-6
BC command 3-5
BF command 3-7
BI command 3-10
big-endian byte ordering 1-34
Binary Coded Decimal (BCD) 5-63
binary number 5-63
block of memory move 3-12, 3-40
block of memory search 3-17
block of memory verify 3-22
blocks 1-23
retrieve 5-42
BM command 3-12
board ID packet 5-69
board identification/information B-3
board information block 3-29
boot
network 3-142
boot device B-1
boot halt
network 3-140
BOOTP 1-30, 3-143
bootstrap operating system 1-25, 3-170
Bootstrap Protocol (BOOTP) 1-30, 3-143
BR command 3-15
branch commands 4-13
break 5-54
check for 5-13
breakpoint
delete 3-15
insert 3-15
temporary 3-79, 3-224
BS command 3-17
BV command 3-22
byte 1-33
byte ordering 1-34
C
CFGA 5-19
change configurable parameters (IOT
command) 1-25
change register 3-200
characters
output 5-47
check for break 5-13
check function 5-79