User`s manual

Disk Status Codes
F-5
F
$09 Clock faster than 75 MHz
$0A Bad Clock parameter - ASCII clock value Zero or Non-ASCII
$0B Queue depth too large (> 255)
$0C Selection timeout
$0D Reselection timeout
$0E Bus error during a data phase
$0F Bus error during a non-data phase
$10 Illegal NCR script instruction
$11 Command aborted - unexpected disconnect
$12 Command aborted - unexpected phase change
$13 SCSI bus hung during command
$14 Data phase not expected by user
$15 Data phase was in wrong direction
$16 Incorrect phase following select
$17 Incorrect phase following message-out
$18 Incorrect phase following data
$19 Incorrect phase following command
$1A Incorrect phase following status
$1B Incorrect phase following rptr message
$1C Incorrect phase following sdptr message
$1D No identify message after re-selection
$1E SIOP failed during script patching
$1F SIOP not attached to SCSI bus
Table F-2. SCSI Firmware Status Codes (Continued)
Code Description