User`s manual

B-1

BSystem Menu

Introduction

Enter the MENU command at either the PPC1-Bug> or

PPC1-Diag> prompt to display the System Menu, which is shown

below.

1) Continue System Start Up

2) Select Alternate Boot Device

3) Go to System Debugger

4) Initiate Service Call

5) Display System Test Errors

6) Dump Memory to Tape

Menu Items

Continue System Start-up

Enter 1 to continue the system start-up and boot sequence. The

system self-tests, followed by the boot routine, either NVRAM Boot

List Boot, Auto Boot, ROMboot, or Network Auto Boot. The boot

routine, and the boot device, are selectable in the ENV command.

Refer to Chapter 3 for information on setting the ENV command

parameters.

If the self-test fails to complete correctly, it may display an error

message. Refer to Appendix C for explanations of these error

messages. Refer to the PPC1Bug Diagnostics Manual for

explanations of some of the self-tests and test error messages.

Select Alternate Boot Device

Enter 2 to receive the following prompts for entering an alternate

boot device: