User`s manual

.PFLASH Function
5-78
5
The next table describes the definitions of the control and status bits
in the Control/Status Word field.
Note: When programming the Flash device in which the
Flash memory is executing, bit 4 will have no effect. All
programming operations that involve the Flash device
in which the Flash memory is executing will be NON-
VERBOSE.
Type
Bit
Position
DeÞnition
Control 0 Execution address valid.
Control 1 Execute address on error as well.
Control 2 Execute local reset.
Control 3 Execute local reset on error as well.
Control 4 Non-verbose, no display messages. (NOTE)
Control 5-15 Unused, Reserved
Status 16 Error of some type, see remaining status bits.
Status 17 Address/Range alignment error.
Status 18 Flash Memory address range error.
Status 19 Flash Memory erase error.
Status 20 Flash Memory write error.
Status 21 VeriÞcation (read after write) error.
Status 22 Time-Out during erase operation.
Status 23 Time-Out during byte write operation.
Status 24 Unexpected manufacturer identiÞer read from the device.
Status 25 Unexpected device identiÞer read from the device.
Status 26 Unable to initialize the Flash device to zero.
Status 27-29 Unused, Reserved
Status 30 Flash Memory program control driver downloaded.
Status 31 No return possible to caller.