User`s manual

PF - Port Format NOPF - Port Detach
3-179
3
You may also enter a special character, either at the prompt or after
typing new data, for
scrolling through the fields. The special
characters are:
Any changes will remain in effect until a reset operation occurs, or
another PF execution. The reset operation, via the debugger, will set
serial ports ÒDEBUGÓ (LUN 0, port 0) and ÒHOSTÓ (LUN 1, port 1)
to the default parameters. (Refer to Auto Boot in Chapter 1 for
details on terminal setup.)
Note Only nine ports may be assigned at any given time.
PORT must be in the range 0 to $1F.
Listing Current Port Assignments
PF lists the names of the PowerPC board and port for each assigned
port number (LUN) when the command is invoked with the port
number omitted.
Example
PPC1-Bug>PF <Return>
Current port assignments: (Port #: Board name, Port name)
[00: MPC603PPC1- “DEBUG”] [01: MPC603PPC1- “HOST”]
Console = [00: MPC603PPC1- “DEBUG”]
PPC1-Bug>
Current port assignments: (Port #: Board name, Port name)
[00: PC16550- "DEBUG"] [01: PC16550- "HOST"]
Console = [00: PC16550- "DEBUG"]
PPC1-Bug>
V or v Go to the next Þeld. This is the default, and remains in
effect until changed by entering one of the other special
characters.
^ Back up to the previous Þeld. This remains in effect until
changed by entering one of the other special characters.
= Re-open the same Þeld
. Terminate the PF command, and return control to the
debugger