User`s manual

NIOP - Network I/O Physical
3-152
3
NIOP - Network I/O Physical
Command Input
NIOP
Description
The NIOP command allows you to get files from the supported
Ethernet network interfaces and put files to the supported Ethernet
network interfaces. When invoked, this command goes into an
interactive mode, prompting you for all parameters necessary to
carry out the command. This command basically uses the TFTP
protocol to perform the file transfer.
The IP addresses for the TFTP session are obtained from the
configuration parameters. The IP addresses are checked to see if the
server and the client are resident on the same network. If they are
not, the gateway IP address is used as the intermediate server to
perform the TFTP session with. The filename character string has a
maximum length of 64 bytes.
Whenever an error occurs, the TFTP session is terminated and the
error code is displayed. The error codes are listed in Appendix H.
Upon successful transfer of the specified file, the TFTP session
statistics are displayed.
When invoked, this command goes into an interactive mode, which
prompts for information required to perform the command. You
may change the displayed value by typing a new value, and the
Return key. To leave the field unaltered, press the Return key
without typing a new value.