User`s manual

NIOC - Network I/O Control
3-147
3
The reset device/channel/node (type 5) would be used if another
operating system (node driver) needs to be control of the
device/channel/node. Basically, put the device/channel/ node to
a known state.
Whenever an error occurs, the initiated I/O control process is
terminated and the appropriate error code is displayed. The error
codes are listed in Appendix H.
When invoked, NIOC enters an interactive mode which prompts
for information required to perform the command. You may
change the displayed value by typing a new value, and the Return
key. To leave the field unaltered, press the Return key without
typing a new value.
You may also enter a special character, either at the prompt or after
typing new data, for
scrolling through the registers. The special
characters are:
The clock must be running in order for this command to work
properly. Use TIME ;L to see if the clock is running. Use the SET
command to start and initialize the clock.
V or v Open the next Þeld. This is the default, and remains in
effect until changed by entering one of the other special
characters.
^ Back up and open the previous Þeld
= Re-open the same Þeld
. Terminate the NIOC command, and return control to the
debugger