User`s manual

NBH - Network Boot Operating System, Halt

3-141

After the registers are initialized, control is returned to the

debugger monitor and the prompt reappears on the terminal

screen. Because control is retained by the debugger, all of the

debugger's facilities are available for debugging the loaded

program if necessary.

The device and controller configuration parameters used when

NBH is initiated can be examined via the NIOT command.

Note that certain arguments will be passed (through MPU

registers) to the loaded program.

Refer to NBO - Network Boot Operating System on page 3-142 for

examples and further explanation.

Note The clock must be running in order for this command

to work properly. Use TIME ;L to see if the clock is

running. Use the SET command to start and initialize

the clock.