User`s manual

MAW - Save Macros
3-122
3
MAW - Save Macros
Command Input
MAW [controllerLUN] [[deviceLUN] [block#]]
Arguments
Description
The MAW command saves the currently defined macros to disk or
tape.
The selected block number, controller LUN, and device LUN are
displayed, followed by a prompt to confirm the save (OK to
proceed (y/n)?).
The list is saved as a series of strings and may take up to three
blocks. If no macros are currently defined, no write is done. A NO
MACRO DEFINED message is displayed.
Default are set each time either MAR or MAW is invoked. When
either command has been used, the default controller, device, and
block numbers are set to those used. If macros were loaded from
controller 0, device 2, block 8 with command MAR, the defaults for
a later invocation of MAW would be the same.
Errors encountered during I/O are reported along with the 16-bit
status word returned by the I/O routines.
controllerLUN Logical Unit Number (LUN) of the controller to
which the following device is attached. This initially
defaults to LUN 0.
deviceLUN LUN of the device to save/load macros to/from. This
initially defaults to LUN 0.
block# Number of the block on the above device that is the
Þrst block of the macro list. This initially defaults to
block 2.