Technical data

2-4

Installation

7. Remove the screws from the stand-offs on the component

side of the MPMC101/MPMC102.

8. Turn the MPMC101/MPMC102 component-side down, and

position it above the carrier board as shown in Figure 2-1 (an

MVME160x carrier board is shown).

Caution

Avoid touching areas of integrated circuitry; static

discharge can damage these circuits.

Note Refer to Figure 2-1 when performing steps 9, 10, and 11.

9. Insert the 68-pin external SCSI-2 connector through the PMC

slot on the carrier boardÕs front panel.

10. Align the keying hole and P1 and P2 connectors on the

MPMC101/MPMC102 over the keying pin and the PMC

connectors on the carrier board.

11. Gently seat the MPMC101/MPMC102 onto the carrier board.

12. Turn the carrier board component-side down, and fasten the

four screws through the carrier board into the stand-offs on

the MPMC101/MPMC102.

13. Install the carrier board in the system chassis.