Technical data

Additional IDE Devices on Your CPX2000 System
http://www.motorola.com/computer/literature 3-47
3
4. Install the mounting screws. Do not tighten until all mounting
screws are in place.
5. Install the power cord.
6. Turn on the second power supply.
7. Verify that the power-on LED on the second supply comes on.
Additional IDE Devices on Your CPX2000
System
CPX2108SK1 systems ship from the factory set as Configuration 2 in
Table 3-6. CPX2108SK2, CPX2208SK3 and CPX2208TSK2 systems ship
from the factory set as Configuration 13 in Table 3-6. Also refer to Table
3-6 for other possible configurations for IDE devices.
Note CPX2208SK2 systems are configured at the factory for use
with Small Computer System Interfaces (SCSI) only.
Configuration 2
❏ CPU hard drive master connected to the primary, Channel 1 located
on the CPU
❏ CPU floppy drive connected to the floppy connector on the CPU
Configuration 13
❏ hard drive in a drive bay, set as Master only, connected to the
primary, Channel 1 on the CPU Transition Module
❏
CD-ROM master in a drive bay, connected to the secondary,
Channel 2 on the CPU Transition Module
❏ floppy drive in a drive bay, connected to the floppy connector on the
CPU Transition Module