Technical data

Removing and Installing “Hot Swap” I/O Modules
http://www.motorola.com/computer/literature 3-17
3
4. Tighten the captive screws on the top and bottom of the panel.
Removing and Installing “Hot Swap” I/O
Modules
This section tells you how to remove and install “hot swap” I/O modules.
!
Warning
Only properly trained service personnel should remove or
install “hot swap” I/O modules. Do not touch bare parts inside
the enclosure because of the possible presence of hazardous
energy levels.
You can remove “hot swap” I/O modules without removing power from
the system. Refer to Appendix D, “Related Documentation” for
information about the PCI Industrial Computer Manufacturer’s Group
(PICMG) Hot Swap Specification.
2245 9805 (i)
Step 2Step 1 Step 3 Step 4