Technical data

3-1

3Installing the CPX2000 Series

System and Field Replaceable Units

Introduction

This chapter gives you information about installing a CPX2000 Series

system. It also gives you information about removing and installing Field

Replaceable Units (FRUs). Refer to Table 3-1 for information about how

this chapter is organized.

Table 3-1. Chapter Organization

You can find information about: On page:

following electrostatic discharge (ESD) and safety

procedures

3-2

safety considerations for lithium batteries 3-3

installing the CPX2000 Series chassis in a 19 inch

rack

3-6

environmental considerations 3-6

cooling the enclosure 3-7

grounding the CPX2000 Series chassis 3-7

connecting the system 3-12

turning on the AC system 3-12

installation troubleshooting 3-10

system cables for the CPX2000 Series chassis 3-12

removing and installing a CPU module 3-14

removing and installing “hot swap” I/O modules 3-17

removing and installing the CPU Transition

Module

3-19

removing and installing the cooling fans 3-22

removing and installing the 3.5 inch floppy drive,

CD-ROM drive or hard disk drive

3-24

removing and installing the power supplies 3-35

additional IDE devices on your CPX2000 system 3-47