Technical data

5-18

Site Preparation and Installation

Data/Control Cables (with Alarm Board)

Refer to Figure 5-6 on page 5-19 while following these procedures.

1. Plug the end of an EIA-232-D cable into the host port of the

terminal to be used as the system console.

2. Plug the other end of the cable into the transition module

connector marked

CONSOLE or SERIAL PORT 1 on the back of

the system.

3. If a SCSI Device Storage Module is present, connect it to the

system as follows:

– Attach one end of a SCSI cable to one of the 68-pin

connectors labeled SCSI on the back of the Storage Module.

– Select a transition module connector labeled

SCSI IN or OUT

on theback of the system. Remove the terminator block

and plug the other end of the SCSI cable into the

connector. Move the terminator block to the unused

connector on the Storage Module.

4. Cable all other associated equipment (terminals, printers,

SCSI expansion peripherals, etc.) to the system as described

in the installation guides for those peripherals.