Technical data

4-12

SCSI Device Storage Module

Removable Media Access Plate Replacement

After removing a removable media drive, or replacing it with a

hard drive, it is necessary to replace the removable media access

plate.

1. Remove the front bezel from the SCSI Device Storage

Module.

2. Slide the removable media access from the back side of the

bezel into the opening (see Figure 4-3). Align the screw holes

with those on the bezel.

3. Tighten the four screws with a Phillips-head screwdriver.

4. Replace the front bezel.

Figure 4-3. Removing the Removable Media Access Plate

2120 9711