Technical data

SCSI Device Storage Module Procedures
4-11
4
Figure 4-2. SCSI Device Storage Module Front Bezel Removal
Removable Media Access Plate Removal
If you have removable media in one or both of the 5 1/4-inch drive
bays, you should remove the access plate from the bezel to give you
access to your media without having to remove the bezel each time.
1. Remove the bezel from the SCSI Device Storage Module.
2. On the back side of the bezel, remove the four screws holding
the access plate in place (see figure Figure 4-3 on page 4-12).
3. Push the face of the plate from the front side of the bezel to
slide the plate back and out.
4. Replace the bezel.
2118 9711