Technical data

4-10

SCSI Device Storage Module

Front Bezel Removal and Replacement (Extended Chassis)

The bezel is required for complete RFI shielding.

Note You need a 4mm Allen wrench to complete these

procedures.

Removal

Refer to figure Figure 4-2 on page 4-11 while performing this

procedure.

1. Unlock the bezel by rotating the locks a quarter-turn inward

from the “locked” position to the “unlocked” position with a

4mm Allen wrench (clockwise on the left side,

counterclockwise on the right).

2. Pull the bezel straight out.

Replacement

1. Press the sides of the bezel against the enclosure until the

bezel is flush with the enclosure.

2. Lock the bezel by rotating the locks a quarter-turn outward

from the “unlocked” position to the “locked” position with a

4mm Allen wrench.