Technical data

4-8
SCSI Device Storage Module
4
SCSI Device Storage Module Procedures
Notes The Rack/Mast and Pedestal mounting procedures are
the same as those for the 3-slot chassis. Refer to Chapter
5: Site Preparation and Installation for this information.
The Pedestal Cover and Side Panel installation
procedures are the same as those for the 3-slot chassis.
Refer to Chapter 2: Original XR Chassis for this
information.
Front Bezel Removal and Replacement (Original Chassis)
The module’s front bezel can be used in both pedestal and
rack/mast chassis configurations. The bezel is required to complete
RFI shielding in either configuration.
Removal
1. Unlatch the bezel from the enclosure by pressing the latch
buttons at either side of the bezel and pulling straight out (see
Figure 4-1 on page 4-9).
Replacement
1. Press the sides of the bezel against the enclosure until the
latches at the sides snap into place.