Technical data

Chassis Use
2-19
2
Side Panel Replacement
The suggested procedure for replacing pedestal side panel
assemblies is as follows:
1. Engage the slots of the panel assembly with the slide hooks
on the enclosure and slide the panel assembly forward until
the latch snaps into place.
2. Repeat step 1 at the opposite side of the chassis.
3. Reinstall the front bezel.
Pedestal Cover Removal and Replacement
The pedestal cover is mounted with the same type of hardware as
the side panels, but no latch is used. Instead, two screws on the back
edge near the corners hold the cover in place. The removal
procedure consists of simply removing the screws, then sliding the
cover backward and disengaging it from the slide hooks.
Replacement is the reverse.