Technical data

9-12

Field Replacable Units

Removal

1. Attach an ESD strap to your wrist. Attach the other end of the

ESD strap to the chassis as a ground. The ESD strap must be

secured to your wrist and to ground throughout the

procedure.

Caution

Avoid touching areas of integrated circuitry; static

discharge can damage these circuits.

2. Perform an operating system shutdown. Turn the AC or DC

power off and remove the AC cord or DC power lines from

the system.

Caution

Inserting/removing modules while power is applied

may result in damage to module components.

3. Remove the chassis’ bezel.

4. Pull the drive firmly until it disconnects from the backplane

connector. It may be necessary to rock the drive from side to

side in order to loosen the connection. Slide the drive the rest

of the way out of the drive bay.

5. Reinstall and lock the bezel.

6. Reconnect the power cord, turn the unit on, and test using

diagnostics.