Technical data

Dual 9-, 12-, and 20-Slot Chassis

9-11

2. Perform an operating system shutdown. Turn the AC or DC

power off and remove the AC cord or DC power lines from

the system.

Caution

Inserting/removing modules while power is applied

may result in damage to module components.

3. Remove the chassis’ bezel.

4. Locate the drive address switch on the SCSI drive to be

installed (see Figure 9-4). Set the drive address by turning the

dial to the desired address number. Allowable addresses are

0-6.

Figure 9-4. SCSI Drive Address Switch

5. Slide the drive gently into the drive bay until it contacts the

backplane connector. Use firm steady pressure to seat the

drive connector in the backplane.

6. Reinstall and lock the bezel.

7. Reconnect the power cord, turn the unit on, and test using

diagnostics.

Address Switch