Technical data

Description
8-11
8
Specifications
VMEbus Interface Signals
The signals and pin assignments for VMEbus connectors J1/P1 and
J2/P2 are listed in Table 8-5 and Table 8-6 on page 8-13. The signals
and pin assignments for VMEbus connector XP2 (the transition
module connector) are listed in Table 8-7 on page 8-14.
Table 8-4. Backplane Specifications
Characteristics Specifications
Physical
characteristics Width
(20-slot)
Width (12-slot)
Width (9-slot)
Height
Thickness
16.7 inches (405 mm)
16.7 inches (405 mm)
7.9 inches (141 mm)
16.5 inches (262 mm)
0.112 inches (2.845 mm) typical
Temperature
Operating
Storage and transit
0° to 55° C (32° to 131° F)
-55° to 85°C (-67° to 185° F)
Relative humidity 0% to 90% noncondensing
Power consumption
(without
VMEmodules)
6 W (1.2 A at +5V), required by terminator
resistor networks
Connectors
VMEbus sockets DIN 41612, type C, 96-pin. Socket spacing
(center to center) 0.8 inch.
Bus termination Permanently mounted 330/470 ohm
resistor networks and discrete resistors