Technical data

Cabling

5-31

Figure 5-10. DC Terminal Block

Note For additional protection if the conditions of the site

call for it, you may wish to also use the chassis ground

point on the rear wall of the unit (the GND connection

with a

/4 x 20 thread located to the upper left of the ESD

bond point). This ground point is to be connected to

the equipment rack or other reliable path to earth

ground.

4. If there is other equipment requiring DC power, cable those

devices to the DC source as described in the associated

installation guides.

5. For AC equipment, such as the system console, plug the

socket end of the unit's power cord into the connector on the

back of the unit.

6. Plug the power cord of the console terminal (and any other

AC equipment) into an electrical outlet.

7. Reapply the DC power to the wires connected to the system.

GROUND

48V

+ | -

Insert

Clamping

Screws

Wires

Here