User`s manual

2-10 MPC564EVB User’s Manual
System Power-up and Initial Operation
RW0, RW2, RW4 – 18, RW23 – 30 provide the user access to external Reset Configuration Word
(RCW) bits not normally required for default MPC564EVB operation. The RW0 – 30 designations
reflect the data bus D0 – D30 bit affected when the RCW word is enabled externally. All RW0 –
30 option bits are defaulted to the logic low value during external RCW word operation. The user
may apply a wire jumper between the 2 pad positions of each RW0 – 30 option to provide a logic
high level on the respective bit position during external RCW operation. Note that the user could
add physical headers (2mm type) to these signals on the board. Refer to the MPC564 user manual
Reset chapter for the respective RCW bit definitions.
2.3.2 Memory Configuration (MAP_SW)
The Memory Configuration switch (MAP_SW) controls the mapping of the MPC564 chip selects
to the different external memories and whether the internal flash is enabled.I
2.4 System Power-up and Initial Operation
When all of the cables are connected to the board, power may be applied. The dBUG ROM Monitor
initializes the board and then displays a power-up message on the terminal.
Part Number: 0xXX
MaskNum: 0xXX
Copyright 1995-2002 Motorola, Inc. All Rights Reserved.
MPC564 MPC564EVB Firmware v3b.1a.xx (Build XXX on XXX XX 20XX
xx:xx:xx)
Enter ’help’ for help.
Table 2-4. MAP_SW
Switch Name MPC563/564
Function
Switch Closed Default
1
CS0
1
1
Each Chip Select should only be connected to one device.
RAM_CS CS0 connected to the External SRAM off
2
CS1
1
RAM_CS CS1 connected to the External SRAM on
3
CS0
1
FL_CS CS0 connected to the External Flash on
4
CS2
1
FL_CS CS1 connected to the External Flash off
5 IP RCW-IP IP bit is set on
6
CS3
1
100_CS/LCD_
CS
CS3 connected to the Ethernet and LCD Interface on
7CS3-TA TA
TA for LCD or Connect the EtherNet Controller TA to the Pro-
cessor TA
on
8 2.6v FLEN Enable Internal MPC563/564 Flash off
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...