Specifications

HARDWARE PREPARATION AND INSTALLATION
2-22 MPC505EVBUM/D
2.3.6 Logic Analyzer Connectors
Use connectors POD1 through POD7 to connect a logic analyzer to the circuit being evaluated.
Below are the pin assignments for the logic analyzer connectors.
POD1 POD2
NC 1 ••2NC NC1••2NC
TS~ 3 ••4 FOE~ NC 3 ••4 A16
CS1~ 5 ••6 CS2~ A17 5 ••6 A18
CS3~ 7 ••8 CS4~ A19 7 ••8 A20
CS5~ 9 ••10 BSWE0~ A21 9 ••10 A22
BSWE1~ 11 ••12 BSWE2~ A23 11 ••12 A24
BSWE3~ 13 ••14 A10 A25 13 ••14 A26
A11 15 ••16 A12 A27 15 ••16 A28
A13 17 ••18 A14 A29 17 ••18 GND (A30)
A15 19 ••20 GND (A31) GND 19 ••20 GND
POD3 POD4
NC 1 ••2NC NC1••2NC
NC 3 ••4 D16 NC 3 ••4D0
D17 5 ••6 D18 D1 5 ••6D2
D19 7 ••8 D20 D3 7 ••8D4
D21 9 ••10 D22 D5 9 ••10 D6
D23 11 ••12 D24 D7 11 ••12 D8
D25 13 ••14 D26 D9 13 ••14 D10
D27 15 ••16 D28 D11 15 ••16 D12
D29 17 ••18 D30 D13 17 ••18 D14
D31 19 ••20 GND D15 19 ••20 GND
HARDWARE PREPARATION AND INSTALLATION
MPC505EVBUM/D 2-19
2.3.4 RS-232C – EVB Interconnection
Interconnection of an RS-232C compatible device to the EVB is accomplished via a user
supplied 9-pin cable assembly. One end of the cable assembly is connected to either EVB port P2
or P3 (shown below). The other end of the cable assembly is connected to the user supplied RS-
232C compatible device. For connector pin assignments and signal descriptions of the EVB RS-
232C ports P2 and P3, refer to Appendix B.
1
2
3
4
5
ADCD
ARXD
ATXD
ADTR
GND
P2
RS-232 DEVICE
6
7
8
9
ADSR
ARTS
ACTS
NC
1
2
3
4
5
BDCD
BRXD
BTXD
BDTR
GND
P3
RS-232 DEVICE
6
7
8
9
BDSR
BRTS
BCTS
NC
Fr
eescale S
emiconduct
or
, I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...