User guide

Receiving an Emergency Alarm

When your radio receives an Emergency Alarm, a

tone sounds and the LED blinks red until you exit

the Emergency mode. Perform one of the

following actions to silence the tone:

• Press the PTT button to call the group of radios

which received the Emergency Alarm.

• Press any programmable button.

• Exit Emergency mode.

Note: Your radio automatically acknowledges the

Emergency Alarm (if enabled).

Exiting Emergency Mode After Receiving the

Emergency Alarm

Exit the Emergency mode by performing one of

the following actions:

• Changing the channel.

• Powering down the radio.

• Pressing the Emergency Off button.

• Pressing the Emergency On button. This

action clears the alarm indication and initiates

an emergency transmission.

Sending an Emergency Alarm

This feature allows you to send an Emergency Alarm,

a non-voice signal, which triggers an alert indication

on a group of radios.

If your radio is set to Silent, it does not display any

audio or visual indicators during Emergency mode.

Press the programmed Emergency On button.

The LED lights up solid green.

When an Emergency Alarm acknowledgement is

received, the Emergency tone sounds and the

LED blinks green.

If your radio does not receive an Emergency

Alarm acknowledgement, and after all retries have

been exhausted, a low-pitched tone sounds.

Radio exits the Emergency Alarm mode.

Sending an Emergency Alarm with Call

This feature allows you to send an Emergency Alarm

to a group of radios. Upon acknowledgement by a

radio within the group, the group of radios can

communicate over a programmed Emergency

channel.

Advanced Features in Non-Connect Plus Mode

English