user manual

Chapter 2: Device Installation
VMM6300 and VMM7300 Assembly Information VMM6300 and VMM7300 Assembly Information
............................................. .............................................
. .
. .
The VMM external connection points are shown and labeled in the figure below. The VMM external connection points are shown and labeled in the figure below.
Figure 2-2 VMM External Connection Points Figure 2-2 VMM External Connection Points
N-Type
Antenna
Connector
Power
Reset
Power
Connector
Ethernet
(Crossover MDI-X)
Installing the VMM Device
.............................................
.
.
The following instructions describe the VMM6300 and VMM7300 hardware installation procedure:
Procedure 2-1 VMM Hardware Installation Procedure
1
Mount the VMM device in a suitable location in a vehicle to allow for ventilation.
The device is not waterproof and should be reasonably protected from
moisture and other exposed outdoor environments.
2
Connect the antenna to the N-type connector.
6881011Y54-A 011Y54-A
2-4 2-4
September 2005 September 2005