Specifications

17
This table describes the connections for the four Mictor 38 connectors
necessary for compatibility with the inverse assembler and the
E5346A high-density termination adapter cables. This is intended to be a
guide for placing probing connectors on a target system.
For inverse assembly, the J1, J2, J3, and J4 connectors listed below must
be connected through the four high-density adapter cables. For simulta-
neous timing and state analysis for all signals, additional connectors must
be used.
Note: * - Active Low
Mictor 38 Logic Analyzer Microprocessor
Conn. Pin# Pod # Bit# Pin# Signal name
J1 38 1 0 P01 A31(LSB)
36 1 J15 A30
34 2 M01 A29
32 3 H16 A28
30 4 K02 A27
28 5 G15 A26
26 6 K01 A25
24 7 G13 A24
22 8 F04 A23
20 9 F16 A22
18 10 H03 A21
16 11 F15 A20
14 12 J02 A19
12 13 F14 A18
10 14 J01 A17
8 15 F13 A16
6 CLK C09 SYSCLK
____________________________________________________________
J1 37 2 0 H02 A15
35 1 E16 A14
33 2 H01 A13
31 3 E15 A12
29 4 G02 A11
27 5 E13 A10
25 6 D04 A9
23 7 D16 A8
21 8 E02 A7
19 9 D15 A6
17 10 G01 A5
15 11 D14 A4
13 12 F02 A3
11 13 D13 A2
9 14 E04 A1
7 15 C16 A0(MSB)
5 CLK
____________________________________________________________
Pin-out Information on
Required Signals for
Inverse Assembly