Specifications

15
Placing the AMP Mictor connectors as close as possible to the signal
source will minimize stub length and ensure a reliable measurement.
Figure 9 shows the connector layout of J1-J5. J1-J4 are required for
inverse assembly, while J5 is optional for timing or state analysis of
I/O ports.
The AMP Mictor connectors are available directly from AMP
(PN 2-767004-2) or from Agilent Technologies (PN E5346-68701). The
Agilent Mictor kit contains five AMP Mictor connectors and five support
shrouds. The signals +5 V DC, SCL, and SDA are not used for probing
and should not be electrically connected to the target system. See figure 10.
A support shroud (Agilent E5346-44701) is recommended to provide
additional strain relief between the E5346A adapter and the AMP Mictor
connector, as shown in figure 13. The shroud fits around the AMP
Mictor connector and requires two through-hole connections to the tar-
get board. Five shrouds are included with five AMP Mictor
connectors in the E5346-68701 kit.
0.276 in
7.01 mm
0.329 in
8.36 mm
0.400 in
10.16 mm
0.996 in
25.30 mm
0.245 in
6.22 mm
0.050 in x 0.017 in (127 mm x 0.43 mm)
pad with 0.005 in (0.13 mm ) x 45°
corner chamfers typ 38
0.040 in
1.02 mm
0.139 in
3.53 mm
TYP
1.190 in
30.23 mm
0.450 in
11.43 mm
Pin 1 chamfer
connector key
∅
∅
0.093 in
2.36 mm
0.032 in
0.81 mm
0.100 in
2.54 mm
TYP
∅
0.030 in
0.76 mm
Mounting holes for
support shroud
Mounting holes for
support shroud
18 Spaces at
0.025 in (0.64 mm)
0.250 in
6.35 mm
± 0.002 in (0.05 mm) plated
+ 0.003 in (0.08 mm)
or -0.001 in (0.02 mm)
Figure 12. AMP Mictor Connector Dimensions
Mictor Connector
Placement
Mictor Connector
Support Shroud