Specifications

5
NAM programming:
Step 3: PROGRAMMING SEQUENCE
1.
Turn the power on. PHONE MUST BE UNLOCK BEFORE IT CAN BE PROGRAMED
2. Within ten seconds enter the access sequence as determined above.
3.
The phone should now show "01" in the left of the display, this is the first programming entry step number. If it does not the
security code is incorrect, or the programming lock-
out counter has been exceeded. In either case you can still program the unit by
following the steps under TEST MODE PROGRAMMING below.
4. The * key is used to increment each step:
Each time you press * the display will increment fro
m the step number, displayed on the left, to the data stored in that step,
displayed on the right. When the data is displayed make any necessary changes and press * to increment to the next step number.
5. The SND key is used to complete and exit programming when any STEP NUMBER is displayed
If you have enabled the second phone number bit in step 10 below then pressing SND will switch to NAM 2. Steps 01 thru 06, 09
and 10 will repeat for NAM 2, the step number will be followed by a "2" to indicate NAM two.
5. The CLR key will revert the display to the previously stored data.
6. The # key will abort programming at any time.
PROGRAMMING DATA:
STEP# #OF DIGITS/RANGE DESCRIPTION
01 00000 - 32767 SYSTEM ID
02 3 DIGITS AREA CODE
03 7 DIGITS TEL NUMBER
04 2 DIGITS STATION CLASS MARK
05 2 DIGITS ACCESS OVERLOAD CLASS
06 2 DIGITS GROUP ID (10 IN USA)
07 6 DIGITS SECURITY CODE
08 3 DIGITS LOCK CODE
09 0333 OR 0334 INITIAL PAGING CHANNEL
10 6 DIGIT BINARY OPTION PROGRAMMING (SEE NOTE 1)
11 3 DIGIT BINARY OPTION PROGRAMMING (SEE NOTE 2)
NOTES: Take care with Motorola's use of "0" and "1". Some options use "0" to enable, some use "1".
1. This is a 6 digit binary field used to select the following options:
Digit 1: Internal handset speaker, 0 to enable.
Digit 2: Local Use Mark, 0 or 1.
Digit 3: MIN Mark, 0 or 1.
Digit 4: Auto Recall, always set to 1 (enabled).
Digit 5: Second phone number (not all phones), 1 to enable.
Digit 6: Diversity (Two antennas, not all phones), 1 to enable.
2. This is a 3 digit binary field used to select the following options:
Digit 1: Continuous DTMF, 1 to enable
Digit 2: Transportable Ringer/Speaker, 0=Transducer, 1=Handset
Digit 3: 8 hour time out in transportable mode, 0 to enable
On newer models they have added and changed some numbers. The numbers as of the 3/27/92 manual are as follows:
1. The 6 digit binary field is still the same.
2. The 3 digit binary field has become a 5 digit binary field.
Digit 1: Failed Page Indicator 1=Disable 0=Enable
Digit 2: Motorola Enhanced Scan 1=Enable 0=Disable
Digit 3: Long Tone DTMF 1=Enable 0=Disable
Digit 4: Transportable Internal Ringer Speaker 1=Handset 0=Transdc
Digit 5: Eight Hour Timeout 1=Disable 0=Enable