Specifications

11
3. Service Level Codes:
001 The telephone will only dial numbers in memory locations 01, 02 and 03. No keypad entries or
memory storage is possible. Restrict ALL outgoing calls by clearing locations 01, 02, and 03
and place the phone in servicing level 001. In some phones this applies to memory locations 01
- 10.
002 The telephone will dial only numbers from memory locations. The keypad is disabled and super
speed dialing is not enabled.
003 Keypad dial only; no memory recall allowed.
004 Unlimited keypad and memory dialing. (DEFAULT)
005 Seven-digit dialing only
006 Full keypad and memory dialing, but memory locations 1 through 10 cannot be changed.
007 The phone will dial only from as many as 50 programmable memory locations
4. (step 10 above, suggested entry is: 00000100)
Digits 1 - 3 Not used in USA, enter 0.
Digit 4 Extended Field. When enabled, the telephone will scan more than 32 paging
channels. Not used in USA, 0 to disable
Digit 5 Single system scan, 1 to enable (scan A or B system only, determined by bit 2 of step
02. Set to "0" to allow user the option).
Digit 6 Super speed dial, 1 to enable (pressing N, or NN SND will dial the number stored in
memory location NN).
Digit 7 User selectable service level, 0 to enable (allows user to set long distance/memory
access dialing restrictions).
Digit 8 Lock function, 0 to enable (allows user to lock/un-lock the phone, if this is set to 1 the
phone can not be locked).
5. (step 11 above, suggested entry is: 00000000)
Digit 1: Handset programming, 0 to enable (allows access to programming mode without having
to enter test mode).
Digit 2: Second phone number (not all phones), 1 to enable.
Digit 3: Call timer access, 0 to enable. (Not used in TDMA)
Digit 4: Auto system busy redial, 0 to enable.
Digit 5: Internal Speaker disable, 1 to enable (use with select VSP units only, do not use with 2000
series mobiles).
Digit 6: IMTS/Cellular, 1 to enable (rarely used).
Digit 7: User selectable system registration, 0 to enable.
Digit 8: Dual antenna (diversity), 1 to enable.
6. (step 16 and 19 above, suggested entry is: 0011010 for portable and 0011011 for mobile units)
Digit 1: Enhanced Scan, when enabled, four strongest signalling channels are scanned instead of
two. 1=enabled, 0-disabled.
Digit 2: Cellular Connection, used only in series II phones if a series I cellular connection is used
with a series II. 0=series II, 1=series I, 0 for ALL TDMA PHONES
Digit 3: Continuous DTMF, 1 to enable (software version 8735 and later)
Digit 4: Transportable Internal Ringer/Speaker. When set to 0, audio is routed to the external
speaker of the transportable; 1 routes it to the handset.
Digit 5: 8 hour time-out, 0 to enable (software version 8735 and later)
Digit 6: Not used, 0 only.
Digit 7: Failed page indicator, 0 to enable (phone beeps when an incoming call is detected but
signal conditions prevent completion of the call).
Digit 8: Portable scan, 0 for portable, 1 for mobile units.