Specifications

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
Note
Before starting, you may want to select a different net to use: see
instructions on page 24.
When MultiNet is enabled, you will be prompted for a net number
as soon as you press CALL (F1) to start a call.
➤ To execute a bidirectional handshake with an individual station:
1. Press LQA (F2) to enter the LQA menu.
LQA
MOTOROLA
BDIR SOND CHAN SELs
2. Press BIDR (F1).
The last called address is displayed. If this is the
address you want, skip directly to Step 6 below.
BIDR
1001
MOTOROLA
SEND PAGE CHAN SELs
3. To select a different address, use the UP/DOWN keys to scroll to the
required address in the directory, and then press ENTER to confirm your
selection.
or
If the station you want to add to the group is not in
the directory:
• Enter the new station using the keypad. If you
make a mistake, scroll to the desired position
using <-- (F2) and/or --> (F3), or clear (CLR
(F4)) the whole entry and start again.
BDIR
BU_
MOTOROLA
SAVE <-- --> CLR
• When ready, press SAVE (F1) to store the new
station in the directory.
DIR
BUD
MOTOROLA
SEND PAGE CHAN OK s
4. Press PAGE (F2) if you wish to attach a message to the bidirectional
handshake process. After confirming the message, exclamation mark
precedes the name of the called station, indicating that a message has been
attached.
5. Press CHAN (F3) if you wish to execute a bidirectional handshake process
on a specific channel.
6. Press SEND (F1) or ENTER in order to initiate the bidirectional handshake
process. During this process, you will see TO alternating with the number of
the channel on which the set up request is being sent.
48
_________________________________________________________________________________________________