Specifications

MICOM-2ES/2RS/2TS ALE Supplement to Owner’s Guide
Compliance and Control Guidelines and Operating Instructions
for Mobile Two-Way Radios Installed in Vehicles
To control your exposure and ensure compliance with the
occupational/controlled environment exposure limits, always adhere to the
following procedures:
• To transmit (talk), push the Push-To-Talk (PTT) button; to receive,
release the PTT button. Transmit only when people outside the vehicle
are at least 7 feet from a properly installed, externally-mounted antenna.
• Install mobile antennas at the center of the roof or the center of the trunk
deck per specific guidelines and instructions in the Radio Installation
Manual. These mobile antenna installation guidelines are limited to metal
body vehicles.
Use only the Motorola-approved, supplied antenna or a Motorola-
approved replacement antenna. Use of non-Motorola-approved antennas,
modifications, or attachments could damage the radio and may violate FCC
regulations.
Compliance and Control Guidelines and Operating Instructions for Mobile
Two-Way Radios Installed as Fixed Site Control Stations
If mobile radio equipment is installed at a fixed location and operated as a control
station or as a fixed unit, the antenna installation must comply with the following
requirements in order to ensure optimal performance and compliance with the RF
energy exposure limits in the standards and guidelines listed in the
Federal
Communication Commission Regulations
section.
• The antenna should be mounted outside the building on the roof or a tower if
at all possible.
• As with all fixed site antenna installations, it is the responsibility of the licensee to
manage the site in accordance with applicable regulatory requirements and may
require additional compliance actions such as site survey measurements, signage,
and site access restrictions in order to ensure that exposure limits are not
exceeded.
iv
________________________________________________________________________________________________