User`s guide

Configuration Settings
68P02953C05 8-7
Figure 8-4. Ra
dio Options
Dialog Box
The following list defines the parameters you configure in the Radio Options dialog box.
Parameter Enables to
Priority Channel Switch to this channel after pressing the priority button on the front panel.
Scan Rate The time interval the radio scans each channel (seconds/channel).
Baud Rate Select the radio’s serial communication baud rate. Selecting the radio baud rate
which is different from the PC’s, may cause communication failures following
restart. (The radio’s baud rate is updated at restart only.)
The baud rate may be changed only if you’re working in technician mode.
Alert Tone Select a low or high radio speaker alert tone.
CW PTT Hold Select the time which elapses between the moment you release the PTT button
until the radio stops to transmit.
Beep After... Select sounding a beep on the close radio, after each keyboard press or select
sounding a beep on the remote radio following PTT release. You may choose one
option or both.
Side Tone Select the audio sources the radio routes to the speaker.You may choose
“Accessory”, “Microphone” or both.
Alt Display Time Select the time length for showing the radio unstable displays on the front panel,
for example the frequency display. Following this interval, the initial display
returns.
Enabled only in
Technician
mode.