User guide

Special Features
If you have at least two handsets registered to your base unit, you can use the intercom
and call transferring features.
Placing an Intercom Call
1. Press
INTERCOM
on any handset.
2. Scroll to and select the handset you wish to page.
3. Answer the page by pressing ON/FLASH , or .
4. Press OFF/CANCEL on either handset to end the call.
NOTE: An out of range intercom call is automatically canceled after a few seconds.
User Guide
24
Access a Call Waiting Line / Holding and transferring calls (PABX)
When on an external call, press ON/FLASH key to access a Call Waiting Line when you hear
the call waiting prompt signal. Press ON/FLASH key again to toggle between the two calls.
When on an external call (PABX line)
1. Press ON/FLASH key to put the call on hold.
2. Dial the number of the extension.
3. Press ON/FLASH key again if you would like to take back the call, or OFF/CANCEL to
transfer the call.
Note : If serval handsets are registered on the base station and a call should be put on hold or
transferred, press the INTERCOM key instead of ON/FLASH.