Specifications

D
evice Driver Programming
10-4
NOTE
This section illustrates the installation procedure for a 13-slot
model of the Series 6000 platform. Different models have differ-
ent configurations of the card enclosures and hardware switches.
Refer to your Installation Manual for configuration details spe-
cific to your particular model.
Installing the Device 10
To install a VME board in the system, use the following steps:
1. Power down the machine.
2. Configure all of the board’s jumpers or DIP switches as required; refer to
the board’s technical reference or installation manual for details.
3. Install the board as shown in Figure 10-1:
Figure 10-1. Installing (H)VME Board into 13-slot Rack
REMOVABLE
POWER SUPPLY
DISK CHASSIS
VME SLOT 8
VME SLOT 0
HVME SLOT 0
CARD NEST
DIP SWITCH
LOCATION
VME SECONDARY
I/O BUS
HVME PRIMARY
I/O BUS
HVME SLOT 3
P1 CONNECTOR
P2 CONNECTOR
P1 CONNECTOR
P2 CONNECTOR
P3 CONNECTOR
VME BOARD
HVME ADAPTER BOARD
CLOCK LOADING BOARD
VME BOARD
B1
A2
163170
A1
C