MC68VZ328 Integrated Processor User's Manual

10-36 MC68VZ328 User’s Manual 
Programming Model
When bit 0 is set as DATA_READY, it can be used in master mode to signal the SPI master to clock out
data. PWMO2 is an output signal from the PWM 2 module. If this pin is configured as this dedicated
function and PKDIR0 is set to 1, the PWMO2 signal is selected. If PKDIR0 is 0, DATA_READY
is
selected. This pin defaults to Port K data bit 0, GPIO input, pulled high.
When selected bit 1 (RW
) is connected to the 68000 CPU Read/Write signal, this pin defaults to Port K
bit 1, GPIO input, pulled high.
The remaining bits are involved with bus control. See Section 2.6, “Bus Control Signals,” on page 2-6 for
more detailed information.
10.4.10.4 Port K Pull-up/Pull-down Enable Register
The pull-up/pull-down enable register (PKPUEN) controls the pull-up and the pull-down resistors for each
line in Port K. The settings for the PKPUEN register bit positions are shown in Table 10-49.
PKPUEN Port K Pull-up/Pull-down Enable Register 0x(FF)FFF442
10.4.10.5 Port K Select Register
The select register (PKSEL) determines if a bit position in the data register (PKDATA) is assigned as a
GPIO or to a dedicated I/O function. The settings for the PKSEL register bit positions are shown in
Table 10-50.
PKSEL Port K Select Register 0x(FF)FFF443
BIT 7654321BIT 0
PD7PD6PD5PD4PU3PU2PU1PU0
TYPE rw rw rw rw rw rw rw rw
RESET
11111111
0xFF
Table 10-49. Port K Pull-up/Pull-down Enable Register Description
Name Description Setting
PUx
Bits 7–0
Pull-up/Pull-down Enable—These bits enable
the pull-up and pull-down resistors on the port.
0 = Pull-up and pull-down resistors are disabled
1 = Pull-up and pull-down resistors are enabled
BIT 7654321BIT 0
SEL7 SEL6 SEL5 SEL4 SEL3 SEL2 SEL1 SEL0
TYPE rw rw rw rw rw rw rw rw
RESET
11111111
0xFF
Table 10-50. Port K Select Register Description
Name Description Setting
SELx
Bits 7–0
Select—These bits select whether the internal chip
function or I/O port signals are connected to the pins.
0 = The dedicated function pins are connected.
1 = The I/O port function pins are connected.