User`s guide

To load the configuration and inverse assembler files

1 Insert the preprocessor interface disk in the front disk drive of the

logic analyzer.

2 Depending on your logic analyzer, select one of the following menus:

• For the HP 1650-series logic analyzers, press the I/O menu key and

use the knob to select "Disc Operations"

• For the HP 1660-series logic analyzers, select the "System Disk" menu

• For the HP 16500A mainframe, select the "System Front Disk" menu

• For the HP 16500B mainframe, select the "System Flexible Disk"

3 Configure the menu to "Load" the analyzer configuration from disk.

4 For HP 16500-series and HP 1660-series logic analyzers, select the

appropriate module (such as "100/500 MHz LA" or "Analyzer") for the

load.

5 Use the knob to select the appropriate configuration file.

Your configuration file choice depends on which analyzer you are using, the

software version(s) of your analyzer software, and, in some cases, which

inverse assembler you want to use. See the summary table following these

instruction steps.

Execute the load operation to load the file into the logic analyzer.

The logic analyzer is configured for MC68306 analysis by loading the

appropriate MC68306 configuration file. Loading this file also automatically

loads the inverse assembler.

The following table lists the correct configuration file to for each logic

analyzer. For more information about the inverse assembler, see Chapter 2.

Setting Up the Preprocessor Interface

To load the configuration and inverse assembler files

MC68306 Preprocessor 1–27