User`s guide

Setting Up the Preprocessor Interface Software
Setting up for the preprocessor interface software consists of the following
major steps:
1
The first time you set up the preprocessor interface, make a duplicate
copy of the master disk.
For information on duplicating disks, refer to the reference manual for your
logic analyzer.
2
Insert the preprocessor interface disk in the front disk drive of the
logic analyzer.
3 Load the appropriate configuration file into the logic analyzer.
Once you have the hardware and software set up, you are ready to make
measurements with the logic analyzer and preprocessor interface. The rest
of this section provides more detailed information on setting up the
preprocessor software.
Setting Up the Preprocessor Interface
To protect the preprocessor interface when not in use
1–26 MC68306 Preprocessor