User`s guide

To connect to the target system
1. To prevent equipment damage, remove power from both the logic
analyzer and the target system.
2. Using the instructions in the "QFP Probe Adapter Assembly
Operating Note," connect the probe adapter assembly to the target
system microprocessor. Ensure that pin 1 is properly aligned.
Caution
Serious damage to the target system or preprocessor interface can result
from incorrect connection. Note the position of pin 1 and pin A1 on the
preprocessor interface, probe adapter assembly, and microprocessor prior
to making any connection. Also, take care to align the preprocessor
interface connector with the pins on the probe adapter assembly so that all
pins are making contact.
The preprocessor interface requires a QFP Probe Adapter Assembly for
connecting to the MC68306 microprocessor. The probe adapter assembly
allows the preprocessor interface to be connected without removing the
microprocessor from the target system. The adapter supports rotations of 0,
90, 180, and 270 degrees. See the next section for information about rotated
connections.
3.
Install the preprocessor interface into the PGA socket on the QFP
probe adapter, again ensuring that pin A1 is properly aligned.
Setting Up the Preprocessor Interface
To connect to the target system
MC68306 Preprocessor 1–7