User`s guide

Setting Up the Preprocessor Interface
Hardware
Setting up for the preprocessor interface hardware consists of the following
major steps:
1
Turn off the logic analyzer and the target system.
Caution To protect your equipment, remove the power from both the logic analyzer
and the target system before you make or break connections. Because the
logic analyzer supplies power to the preprocessor interface, the logic
analyzer should always be powered up before the target system; when
powering down, power down the target system first and then power down
the logic analyzer.
23
Install the preprocessor interface in the target system.
4 Connect the logic analyzer pods to the cable connectors of the
preprocessor interface board.
The remainder of this section contains a separate subsection for each logic
analyzer this interface supports that show the analyzer pod cable
connections.
The remainder of this section describes these general steps in more
detail.
MC68306 Preprocessor 1–5