Specifications

MC3000 Integrator Guide2-32
USB Connection Setup
The USB communication setup is used to set up to communicate between the host and the mobile computer using either a Single Slot
Serial/USB cradle or using one of the serial MC3000 Communication/Charge cables.
For serial communication using the Single Slot Serial/USB cradle, connect only the USB cable, do not connect both the
USB cable and the serial cable. If both serial and USB communication cables are required, the host computer USB port
is the default setting in ActiveSync.
1. On the mobile computer, Series 3000 Demo window double-tap the Ctl Panel icon and double-tap on Comm Settings. The
Comm Settings, window appears.
Figure 2-39. Comm Settings Window
2. Confirm that the Comm port default value is set to USB. If it is not set to USB then with Port highlighted, use the left
and right arrow buttons to set the value to USB.
3. Tap OK to exit the Comm Settings window.
4. Tap X to exit the Control Panel window.
5. Ensure that ActiveSync was installed on the host computer and a partnership was created. See Setting Up an ActiveSync
Connection on the Host Computer on page 3-4 for more information.
6. If ActiveSync is not running on the host computer, select Start - Programs - Microsoft ActiveSync to start ActiveSync, to start
7. Start ActiveSync, if it is not running on the host computer. To start, select Start - Programs - Microsoft ActiveSync.
Figure 2-40. ActiveSync - Not Connected