Specifications
Table Of Contents
- MC3000
- Revision History
- Contents
- About This Guide
- Getting Started
- Introduction
- Unpacking the Mobile Computer
- Accessories
- Parts
- Mobile Computer Startup
- Battery Charging
- Spare Battery Charging
- Stylus
- Starting the Mobile Computer
- Resetting the Mobile Computer
- Waking the Mobile Computer
- Main Battery Removal
- Strap/Door Assembly Removal and Replacement
- Strap/Door Assembly Removal and Replacement (MC3090-G)
- File System Directory Structure
- Flash Storage
- Launching Applications
- Accessories
- ActiveSync
- Software Installation on Development PC
- Software Installation on Mobile Computer
- Creating/Loading Hex Images
- Wireless Applications
- AirBEAM Smart
- Rapid Deployment Client
- Maintenance & Troubleshooting
- Technical Specifications
- Glossary
- Index
- Tell Us What You Think...
Accessories 2-21
Secure Device Card
The Secure Device (SD) card provides secondary non-volatile storage (the flash memory is slower than RAM). The SD card holder is
located under the battery.
Follow proper Electro-Static Discharge (ESD) precautions to avoid damaging the SD card. Proper ESD
precautions include, but are not limited to, working on an ESD mat and ensuring that the operator is properly
grounded.
Do not use the SD card slot for any other accessories.
Select SD cards with environmental and/or the write cycle performance specifications that meet or exceed
the application requirements.
To insert the SD card:
1. Remove the battery (see Main Battery Removal on page 1-16).
2. Lift the SD card retaining door.
3. Position the SD card, with the contacts down, into the SD card slot. The SD card corner notch fits into the slot only one way.
4. Snap the retaining door closed.
Figure 2-20. Inserting the SD card
5. Replace the battery (see Install Main Battery on page 1-7).
SD Card Retaining Door
SD Card