Specifications

10 MC17/MC17A/MC17T/MC17U Mobile Computer
1. Place the mobile
computer on a
desktop with the
display facing
down.
2. Using a T6 Torx
drive, remove two
screws securing
the bezel to the
housing.
3. Align the
replacement bezel
on the housing.
4. Using a T6 Torx
drive, secure the bezel to the housing using the two
Torx screws.
5. Torque the screws to 2.5 ± 0.2 kgf-cm (2.17 ± 0.17
in-lbs.).
Troubleshooting
Problem Cause Solution
Mobile
computer
does not turn
on.
Battery not
charged.
Charge or replace the battery.
Battery not
installed
properly.
Install the battery properly.
See Installing the Battery on
page 4.
The system is
not respond-
ing.
Perform a warm boot. If the
mobile computer still does not
turn on, perform a cold boot.
Mobile Com-
puter is in a
critical sus-
pend state due
to low battery.
Place the mobile computer in
the Charging cradle. The
mobile computer re-boots and
begins charging.
Depending on how depleted
the battery is, the mobile com-
puter may take up to five min-
utes before it turns on.
Recharge-
able battery
did not
charge.
Battery failed. Replace battery. If the mobile
computer still does not oper-
ate, perform a warm boot. See
Resetting the Mobile Com-
puter on page 9.
Mobile com-
puter removed
from cradle
while battery
was charging.
Insert mobile computer in cra-
dle. The battery fully charges
in approximately five hours.